Scan Tool Data Definitions

8-DIGIT GM PART NUMBER: The scan tool displays an 8-digit alphanumeric number. This is the modules part number.

BATTERY VOLTAGE: The scan tool displays 0-30 Volts. The voltage measured between the module's battery positive voltage circuit and ground circuit.

CALIBRATION ID: The scan tool displays a 4-digit alphanumeric number. This number designates the modules calibrations.

DRIVER DOOR JAMB SW.: The scan tool displays On/Off. Display indicates the state of the driver door jamb switch. On indicates the door is open and Off indicates the door is closed.

IGN. ACCESSORY: The scan tool displays Active/Inactive. The scan tool displays Active when only the Accessory and Unlock circuits of the DIM receives a battery voltage signal from the ignition switch.

IGNITION CRANK/RUN: The scan tool displays Active/Inactive. The scan tool displays Active when the Crank/Run and Unlock circuits of the DIM receives a battery voltage signal from the ignition switch.

IGN. RUN: The scan tool displays Active/Inactive. The scan tool displays Active when the Run, Accessory, Run/Crank and Unlock circuits of the DIM receives a battery voltage signal from the ignition switch.

IGNITION SWITCH: The scan tool displays Accy./Crank/Off/RAP/RAP-Unlock/Run/Unlock. The scan tool displays Accy. when the accessory and Unlock circuits of the DIM receives a battery voltage signal from the ignition switch. The scan tool displays Crank when the Crank/Run, and Unlock circuits of the DIM receives a battery voltage signal from the ignition switch. The scan tool displays Off when none of the power moding circuits of the DIM receive a battery voltage signal from the ignition switch. The scan tool displays RAP (Retained Accessory Power) when RAP is active and none of the power moding circuits of the DIM receive a battery voltage signal from the ignition switch. The scan tool displays RAP-Unlock when RAP is active and the Ign. Unlock circuit of the DIM receives a battery voltage signal from the ignition switch. The scan tool displays Run when all of the power moding circuits of the DIM receive a battery voltage signal from the ignition switch. The scan tool displays Unlock when the Unlock circuit of the DIM receives a battery voltage signal from the ignition switch.

IGN. UNLOCK: The scan tool displays Active/Inactive. The scan tool displays Active when only the Unlock circuit of the DIM receives a battery voltage signal from the ignition switch.

JULIAN DATE OF BUILD: The scan tool displays 3-digit numeric number. This is the day of the year that the module was built.

PASS. DOOR JAMB SW.: The scan tool displays On/Off. Display indicates the state of the passenger door jamb switch. On indicates the door is open and Off indicates the door is closed.

PROM ID: The scan tool displays a 4-digit alphanumeric number. This is modules internal PROM identification number.

RAP OUTPUT: The scan tool displays On/Off. Display indicates the status of the RAP function.