Steering Column Trim Covers - Assemble

1. If necessary, install the closeout trim cover (2) onto the upper trim cover (1).





Notice: Refer to Fastener Notice in Service Precautions.

2. Install the upper trim cover (1) with the closeout trim cover (2) and secure by using 1 TORX(R) head screw (3).
- Tighten the screw to 1.5 Nm (13 inch lbs.).





Important: The shift lever seal must seat correctly in the trim covers.

3. Install the lower trim cover (1).
4. Connect the lower trim cover (1) to the closeout trim cover.
5. Install 2 pan head tapping screws (2).
- Tighten the screws to 3.5 Nm (31 inch lbs.).
6. Install the tilt lever.