Turn Signal & Multifunction Switch - Assemble

Important: The electrical contact on the turn signal and multifunction switch assembly must rest on the turn signal cancel cam assembly.

Install the turn signal and multifunction switch assembly.

Notice: Refer to Fastener Notice in Service Precautions.

1. Secure by using 2 pan head tapping screws.
- Tighten the screws to 7 Nm (62 inch lbs.).





2. Reconnect the connectors of the turn signal and multifunction switch assembly.

Notice: Improper routing of the wire harness assembly may damage the inflatable restraint steering wheel module coil. This may result in malfunction of the inflatable restraint steering wheel module coil.

3. Install the wire harness straps.
4. Install the wire harness assembly into the wire restraint clip (1).
5. Install the upper and lower trim covers.
Steering Column Trim Covers - Assemble