Windshield Wiper & Washer Switch - Assemble

1. Slide the windshield wiper and washer switch assembly into the signal switch housing so that the locking tabs snap into place.
2. Connect the windshield wiper and washer switch assembly connector.





Notice: Improper routing of the wire harness assembly may damage the inflatable restraint steering wheel module coil. This may result in malfunction of the inflatable restraint steering wheel module coil.

3. Install the wire harness straps.
4. Install the wire harness assembly into the wire restraint clip (1).
5. Install the upper and lower trim covers.
Steering Column Trim Covers - Assemble