SECURITY Indicator Operation

The theft deterrent controller (VTD) module can command the instrument cluster to flash the SECURITY indicator ON and OFF or illuminate the SECURITY indicator ON steady only when the ignition key is in the ON position. The Rear Integration Module (RIM) can command the instrument cluster to flash the SECURITY indicator ON and OFF or illuminate the SECURITY indicator ON steady only when the ignition key is in the OFF position. The security indicator does illuminate during the bulb check when the ignition is turned to ON for 5 seconds. If the PCM loses communication with the VTD module, the instrument cluster will also detect the loss of communication and will illuminate the SECURITY indicator. The SECURITY indicator can indicate both malfunctions (Indicator on steady) and tamper (Indicator flashing - indicating unauthorized operation). Under the following conditions the SECURITY indicator may be commanded to illuminate.

SECURITY Indicator Stays Illuminated and Engine Starts
If the theft deterrent controller (VTD) module was unable to measure the ignition key transponder value or the PCM lost communication with the VTD module while the engine was last running, the indicator will remain illuminated during subsequent ignition cycles. This is to remind the driver that the vehicle theft deterrent system will not be functioning until the problem is corrected. The vehicle is fail enabled and will start.

SECURITY Indicator Illuminates when Engine is Running
If the theft deterrent controller (VTD) module is unable to measure the ignition key transponder value or the PCM loses communication with the VTD module while the engine is running, the indicator will be illuminated. If the key is turned to OFF, the vehicle will be fail enabled and will start if the condition still exists at the next attempt to start the vehicle.

SECURITY Indicator Illuminated and Engine Does Not Start
The theft deterrent controller (VTD) module or the PCM has detected a problem with the theft deterrent system. The VTD module is unable to measure the ignition key transponder value. The System is in Learn Mode, refer to Programming Theft Deterrent System Components.

SECURITY Indicator Flashes and Engine Does Not Start
The theft deterrent controller (VTD) module has measured an incorrect transponder value when the ignition key is turned to the ON position. The transponder has not been learned by the VTD module. This is considered a tamper condition by the VTD module.