Instrument Panel Module Replacement

REMOVAL PROCEDURE




1. Remove the left sound insulator. Refer to Closeout/Insulator Panel Replacement - Left in Instrument Panel, Gauges and Warning Indicators.
2. Remove the fastener (2) from the Instrument Panel Module (IPM).
3. Rotate the IPM up and out of the IP retainer.
4. Disconnect the electrical connectors from the IPM (1).

INSTALLATION PROCEDURE




1. Connect the electrical connectors to the IPM (1).
2. Install the IPM (1) to the IP retainer by inserting the top tab of the module into the slot on the IP retainer and rotating down.

NOTE: Refer to Fastener Notice in Service Precautions.

3. Install the fastener.

Tighten
Tighten fastener to 2 N.m (18 lb in).

4. Install the left sound insulator. Refer to Closeout/Insulator Panel Replacement Left in Instrument Panel, Gauges and Warning Indicators.