Door Locks: Service and Repair

REMOVAL PROCEDURE




1. Place the window in the full up position.
2. Remove the door trim panel.
3. Peel the rear of the water deflector far enough away from the door to access the outside door handle.
4. Remove the outside door handle.
5. Remove the E-clip (3) on the lock cylinder to remove the lock rod and arm (2).
6. Spread the omega clip (1).
7. Remove the lock cylinder from the backside of the door handle (4).

INSTALLATION PROCEDURE




1. If installing a new lock cylinder refer to Key and Lock Cylinder Coding. If reusing lock cylinder proceed to step 2.
2. Snap the lock cylinder into the outside door handle (4) from the backside.




3. Install the lock cylinder rod and arm (2) to the lock cylinder with the E-clip (3).
4. Install the outside door handle.
5. Install the water deflector.
6. Install the door trim panel.