Front Seat Cushion Replacement

Front Seat Cushion Replacement

Removal Procedure

Caution: Refer to SIR Handling Caution in Service Precautions.

1. Disable the SIR System. Refer to Disabling the SIR System in Restraint Systems.




2. Move the seat to the full forward position.
3. Remove the fasteners (1) securing the seat cushion to the seat adjuster assembly.
4. Lift the front of the seat cushion upwards.
5. Remove the power seat switches.

Notice: Refer to Electrical Wiring Routing Notice in Service Precautions.

6. Disconnect the wiring harness fastener and retainers securing the wiring harness to the bottom of the seat cushion frame.
7. Remove the memory seat module from the seat cushion frame, if equipped.
8. Pull the cushion forward in order to remove the seat cushion from the seat adjuster assembly.

Installation Procedure




1. Insert the seat cushion locators, at the rear of the seat cushion frame, into the rectangular openings in the seat adjuster assembly.
2. Install the memory seat module to the seat cushion frame, if equipped.
3. Secure the wiring harness to the seat cushion frame in the same position in which it was removed.
4. Install the power seat switches.
5. Lower the front of the seat cushion down into position onto the seat adjuster assembly.

Notice: Refer to Fastener Notice in Service Precautions.

6. Install the seat cushion fasteners (1).

Tighten the fasteners (1) to 9 N.m (80 lb in).

7. Enable the SIR. Refer to Enabling the SIR System in Restraint Systems.