Cylinder Head Replacement - Left

Cylinder Head Replacement - Left

^ Tools Required
^ J 36660-A Electronic Torque Angle Meter

Removal Procedure





1. Remove the lower intake manifold.
2. Remove the left exhaust manifold.
3. Remove the left valve rocker arm cover.
4. Remove the electronic ignition module.
5. Remove the valve rocker arm assemblies and the pushrods.





6. Remove the cylinder head bolts. Discard the bolts.
7. Remove the cylinder head.
8. Remove the cylinder head gasket.
9. Clean all of the gasket mating surfaces.
10. Clean and inspect the cylinder head.

Installation Procedure

Notice: This engine uses special torque to yield head bolts. This design bolt requires a special tightening procedure. Failure to follow the given procedure will cause head gasket failure and possible engine damage.





1. Clean the threads in the block. Using the appropriate tap.
2. Install the head gasket with the arrow pointing to the front of the engine.





3. Install the cylinder head.

Notice: Refer to Fastener Notice in Service Precautions.





4. Install the new cylinder head bolts.
^ ^ Tighten the cylinder head bolts in sequence (1-8) to 50 Nm (37 ft. lbs.).
^ Rotate each bolt 120 degrees in sequence (1-8). Use the J 36660-A.
5. Install the valve rocker arm assemblies and the pushrods.
6. Install the electronic ignition module.
7. Install the left valve rocker arm cover.
8. Install the left exhaust manifold.
9. Install the lower intake manifold.