Air Temperature Door Replacement

REMOVAL PROCEDURE




1. Remove the HVAC Module.
2. Remove the mode actuator.
3. Remove the recirculation actuator.
4. Remove the right temperature actuator.
5. Remove the left temperature actuator.
6. Remove the fasteners that retain the mode actuator bracket.
7. Remove the mode actuator bracket.
8. Remove the upper module case fasteners.
9. Peel back the foam at the heater inlet.




10. Remove the upper case.




11. Remove the temperature door.

INSTALLATION PROCEDURE




1. Install the temperature door.




2. Install the upper module case.

NOTE: Refer to Fastener Notice in Service Precautions.

3. Install the module case fasteners.

Tighten
Tighten the fasteners to 1.4 N.m (12 lb in).




4. Reapply the foam at the heater inlet.
5. Install the mode actuator and bracket.
6. Install the left temperature actuator.
7. Install the right temperature actuator.
8. Install the recirculation actuator.
9. Install the HVAC module.