Shift Lever - Assemble

1. Install the shift lever seal (2) onto the shift lever (4).

Notice: Refer to Fastener Notice in Service Precautions.

2. Install the shift lever (4) and secure it with the shift lever screw (3).
- Tighten the screw to 1.5 Nm (13 inch lbs.).
3. Slide the shift lever seal (2) down the shift lever (4).





4. Reconnect the shift lever connector.





Notice: Improper routing of the wire harness assembly may damage the inflatable restraint steering wheel module coil. This may result in malfunction of the inflatable restraint steering wheel module coil.

5. Install the wire harness straps.
6. Install the wire harness assembly into the wire restraint clip (1).
7. Install the upper and lower trim covers.
Steering Column Trim Covers - Assemble