Tie Rod: Service and Repair

- Tools Required
- J 24319-B Universal Steering Linkage Puller

Removal Procedure





1. Raise and support the vehicle.
2. Remove the tire and wheel.
Service and Repair

3. Remove the lock nut (3) from the outer tie rod (1).





4. Loosen the jam nut (2) on the inner tie rod (1).





5. Using J 24319-B remove the outer tie rod from





6. Remove the outer tie rod (3) from the inner tie.

Installation Procedure





1. Install the outer tie rod (3) to the inner tie rod (1). Do not tighten the jam nut (2).





2. Install the outer tie rod (1) to the steering knuckle (2).





Notice: Refer to Fastener Notice in Service Precautions.

3. Install the outer tie rod lock nut (3).
- Tighten the outer tie rod lock nut to 75 Nm (55 ft. lbs.).

Important: Be sure the rack and pinion boot is not twisted or puckered during toe adjustment.

4. Install the tire and wheel.
5. Lower vehicle.
6. Adjust the toe alignment.
Front Wheel Toe Adjustment