P1626
CIRCUIT DESCRIPTIONThe body control module (BCM) produces the theft deterrent fuel enable signal when ignition is ON and the proper key resistor pellet is sensed. The powertrain control module (PCM) monitors the fuel enable signal during crank. If the proper signal is present on the theft deterrent fuel enable circuit, the PCM enables fuel delivery to allow the engine to start. If the PCM detects that the fuel enable signal is not present or incorrect while the engine is running, DTC P1626 will be set. DTC P1626 can cause a no-start condition or normal operation depending on when the loss of the fuel enable signal was detected. The engine will continue to start and run if the condition that set DTC P1626 occurred after the BCM sensed the proper key resistor pellet and signaled the PCM to continue fuel delivery. The engine will start and immediately stall if the condition that set DTC P1626 occurred before the BCM sensed the proper key resistor pellet. With this condition present, the PCM will inhibit fuel delivery and the BCM will disable the starter.
CONDITIONS FOR RUNNING THE DTC
The engine is running.
CONDITIONS FOR SETTING THE DTC
^ The PCM detects an incorrect signal on the theft deterrent fuel enable circuit.
^ The condition is present for more than 2 seconds.
ACTION TAKEN WHEN THE DTC SETS
^ The PCM will not illuminate the malfunction indicator lamp (MIL).
^ The PCM will store conditions which were present when the DTC set as Failure Records data only. This information will not be stored as Freeze Frame data.
CONDITIONS FOR CLEARING THE MIL/DTC
^ A History DTC will clear after 40 consecutive warm-up cycles have occurred without a malfunction.
^ The DTC can be cleared by using a scan tool.
DIAGNOSTIC AIDS
Many situations may lead to an intermittent condition. The following list is to be used as a guide to assist in detecting an intermittent:
^ Loose terminal connection.
Inspect the harness connectors for backed out terminals, improper mating, broken locks, improperly formed or damaged terminals, and faulty terminal to wire connection. Refer to Diagrams for diagnosis and repair.
^ Damaged harness.
Inspect the wiring harness for damage. If the harness inspection does not reveal a problem, observe the display on the scan tool while moving connectors and wiring harnesses related to the sensor. A change in the scan tool display may indicate the location of the fault. Refer to Diagrams for diagnosis and repair.
^ Inspect the PCM and the engine grounds for clean and secure connections.
TEST DESCRIPTION
Steps 1-3:
Steps 4-14:
The numbers below refer to the step numbers on the diagnostic table.
5. This step tests the integrity of the ignition key resistor circuits.