Convertible Top Motor: Service and Repair

Power Folding Top Pump with Motor Replacement

Removal Procedure




1. Remove the left rear compartment side trim panel.
2. Disconnect the electrical connector from the pump.
3. Remove the cylinder hose (1,3) from the pump (5).
4. Use a shop towel in order to control hydraulic oil leakage.
5. Remove the pump nuts (6).
6. Remove the pump (5) with the motor.

Installation Procedure




1. Install the pump (5) with the motor.

Notice: Refer to Fastener Notice in Service Precautions.

2. Install the pump nuts (6).

Tighten the nuts to 6 N.m (53 lb in).

3. Install the cylinder hose (1,3) to the pump (5).

Tighten the cylinder hose fittings to 7 N.m (62 lb in).

4. Connect the electrical connector to the pump.
5. Install the left rear compartment side trim panel.