Seat Track: Service and Repair

Seat Adjuster Horizontal Actuator Adjustment

Adjustment Procedure

With the seat adjuster installed, chucking or jerking can be corrected by tightening or loosening the horizontal actuator and pinion gear to the adjuster lower track rack gear.

1. Operate the seat to a 3/4-forward position.




2. Loosen the bolt (1).
3. Perform the following steps at the same time.

1. Use a large screwdriver in order to apply 67-111 N.m (15-25 lb ft) of outward pressure on the actuator (2).
2. Use the horizontal adjuster switch to move the seat forward and backward.
This will help position and secure the horizontal actuator pinion gear teeth to the lower track rack gear teeth, eliminating any free play.

Notice: Refer to Fastener Notice in Service Precautions.

3. While keeping pressure on the actuator (2), tighten the bolt (1).

Tighten the bolt to 28 N.m (20 lb ft).