Tow Hook Replacement (Rear Pontiac (Export))

Tow Hook Replacement (Rear Pontiac (Export))

Removal Procedure

1. Raise and suitably support the vehicle. Refer to Vehicle Lifting.




2. Remove the rear tow hook bolt.
3. Remove the rear tow hook from the vehicle.




4. Remove the rear tow hook spacer, if necessary perform the following:

1. Remove the rear bumper impact bar.
2. Unclip the spacer from the lower flange of the longitudinal rail.
3. Rotate the spacer 90 degrees.
4. Remove the spacer through the access slot in the rear end panel.

Installation Procedure




1. Install the rear tow hook spacer, if necessary perform the following:

1. Install the spacer through the access slot in the rear end panel.
2. Rotate the spacer 90 degrees.
3. Clip the spacer to the lower flange of the longitudinal rail.
4. Install the rear bumper impact bar.




2. Install the rear tow hook to the vehicle.

Notice: Refer to Fastener Notice in Service Precautions.

3. Instal the rear tow hook bolt.

Tighten the rear tow hook bolt to 205 N.m (151 lb ft).

4. Lower the vehicle.