Bracket and Rod Assembly

REMOVAL PROCEDURE




1. Remove the throttle actuator control (TAG) module and bracket assembly from the vehicle. Refer to Accelerator Pedal Position (APP) Sensor Replacement.
2. Disconnect the plastic link (3) from the TAC module arm and discard.
3. Remove the bolts (2) retaining the TAC module (1) to the bracket (4).
4. Remove the TAG module (1) from the bracket (4).

INSTALLATION PROCEDURE

IMPORTANT: When the bracket and pedal assembly is replaced, the APP Min Reset must be performed using the scan tool output function.




1. Install the bracket (4) to the TAC module (1).

NOTE: Refer to Fastener Notice in Service Precautions.

2. Install the bolts (2) that retain the TAC module (1) to the bracket (4).

Tighten
Tighten the bolts to 6 N.m (53 lb in).

IMPORTANT: This link (3) must not be damaged at installation.

3. Connect the plastic link (3) to the TAC module arm.
4. Install the TAC module (1) and bracket assembly (4) to the vehicle. Refer to Accelerator Pedal Position (APP) Sensor Replacement
5. Perform the APP Min Reset using the scan tool.