Operation CHARM: Car repair manuals for everyone.

Intermediate Steering Shaft

Removal Procedure

Notice: The vehicle's wheels must be in a straight-ahead position and the key must be in a LOCK position when removing or installing the steering column. Failure to do so may cause the SIR coil assembly to become uncentered and may result in unneeded SIR system repairs.





1. Remove the clamp (11) from the boot (12).
2. Remove the boot (12) from the shaft (5).
3. Remove the steering gear bolt (10) from the gear (8).
4. Remove the shaft (5) from the steering gear (8).
5. Remove the shield (14) from the shaft (5) and column (3) on 5.7L VIN G only.
6. Remove the bolt (13) from the column (3).
7. Remove the shaft (5) from the column (3).

Installation Procedure





1. Position the shaft (5) to the column (3).

Notice: Refer to Fastener Notice in Service Precautions.

2. Install the column bolt (13).
- Tighten the column bolt (13) to 47 Nm (35 ft. lbs.).
3. Position the shaft (5) to the gear (8).
4. Install the steering gear bolt (10).
- Tighten the steering gear bolt (10) to 47 Nm (35 ft. lbs.).
5. Install the boot (12) to the shaft (5).
6. Use a clamp (11) in order to secure the boot to the shaft.
7. Position the shield (14) to the shaft (5) and column (3) on 5.7L VIN G only.
8. On 5.7L VIN G only, insert the button into the hole in the column (3) in order to install the shield (14).