SIR Steering Wheel Module Coil - Disassemble

- Tools Required
- J 41352 Modular Column Holding Fixture





1. Set the steering column and J41352 into a vise.

Important: Align the block tooth on the race and upper shaft assembly to the 12 o'clock position. Remove only those components necessary to do the repairs.

2. Check the steering column jacket assembly for any accident damage. Refer to Steering Column Accident Damage Inspection - Off Vehicle.
3. Place the ignition in the LOCK position to center the inflatable restraint steering wheel module coil.
4. Remove the wire harness assembly strap (1).





5. Remove the retaining ring from the steering shaft assembly.





6. Remove the wire harness straps and the wire protector from the steering column.
7. Disconnect the inflatable restraint steering wheel module coil connector at the base of the steering column, if needed.
8. Remove the inflatable restraint steering wheel module coil from the steering shaft assembly.
9. Attach mechanics wire to the inflatable restraint steering wheel module coil connectors for reassembly.
10. Pull the inflatable restraint steering wheel module coil connectors through the steering column, if needed.