Turn Signal & Multifunction Switch - Disassemble

1. Remove the tilt lever.
2. Remove the multifunction lever.
3. Remove the hazard knob.
4. Remove the turn signal cancel cam and upper bearing inner race. Refer to Turn Signal Cancel Cam and Upper Bearing Inner Place - Disassemble - Off Vehicle.
5. Remove the round washer head screw (2) From the signal switch arm assembly (3).
6. Pry out the signal switch arm assembly (3) from the lock housing cover and sleeve assembly.
7. Remove the 3 pan head 6-lobed socket screws (1) from the turn signal and multifunction switch assembly.





8. In order to remove the turn signal and multifunction switch assembly, use the following steps:
8.1. Remove the steering column wire harness strap.
8.2. Remove the wiring protector.





9. Disconnect the terminal connector from the turn signal and multifunction switch assembly connector.
10. Pull the turn signal and multifunction switch assembly connector through the steering column, if needed.