Windshield Wiper & Washer Switch - Assemble

1. Install the windshield wiper and washer switch assembly to the lock housing cover and sleeve assembly.
2. Lubricate the switch actuator pivot pin (2) with lithium grease.
3. Install the switch actuator pivot pin (2) into the windshield wiper and washer switch assembly (1) and the lock housing cover and sleeve assembly.

Notice: Refer to Improper Routing of the Wire Harness Notice in Service Precautions.

Important: Pull carefully on all the wires to remove any wire kinks that may be inside the steering column assembly.
4. Pull the windshield wiper and washer switch assembly wire harness through the steering column.
5. Install the windshield wiper and washer switch assembly connector to the bulkhead connector.
6. Install the wire protector shield.
7. Install the lock housing assembly. Refer to Lock Housing Assembly - Assemble - Off Vehicle.