Rear Lower

Removal Procedure

Important: If replacing both lower control arms, remove and replace only one control arm at a time in order to prevent the rear axle from rolling or slipping sideways.





1. Raise and suitably support the vehicle. Refer to Vehicle Lifting.
2. Remove the lower control arm bolts (5), nuts (2) and washers (4) from the rear axle (1).
3. Remove the lower control arm bolts, nuts and washers from the underbody pan.
4. Remove the lower control arm (3).

Installation Procedure





1. Position and align the lower control arm (3) to the rear axle (1) and the underbody pan

Important: Do not tighten the bolts unless the suspension is at the curb height position.

Notice: Refer to Fastener Notice in Service Precautions.

2. Install the lower control arm bolts (5), washers (4) and nuts (2) to the rear axle (1) from the inboard side out.
- Tighten the lower control arm bolts (5) to 118 Nm (87 ft. lbs.).
3. Remove the adjustable rear axle support.
4. Lower the vehicle.