Rear Coil Spring Replacement

Removal Procedure





Important: When raising the vehicle, support the vehicle by the frame, allowing the suspension to fully extend (unloaded).

1. Raise and suitably support the vehicle. Refer to Vehicle Lifting.
2. Support the rear axle (2) with an adjustable jack stand.
3. Remove the shock absorber to rear axle nut.

Notice: Do not suspend rear axle by brake hoses. Damage to hoses could result.

4. Slowly lower the rear axle (2).
5. Remove the rear coil spring (1).

Installation Procedure





Important: The lower end of the rear spring should be facing forward. Do not chip or damage the corrosion protection coating on the rear spring. Avoid contact with hard steel. If the coating is chipped or damaged, replace the rear spring.

1. Install the rear spring (1) to the rear axle (2).
2. Raise the rear axle (2).

Notice: Refer to Fastener Notice in Service Precautions.

3. Install the shock absorber to rear axle nut.
- Tighten the shock absorber to rear axle nut to 90 Nm (66 ft. lbs.).
4. Remove the rear axle support.
5. Lower the vehicle.