P0134

CIRCUIT DESCRIPTION
The Powertrain Control Module (PCM) supplies a voltage of approximately 450 mV between the Heated Oxygen Sensor (HO2S) high and low signal circuits. The heated oxygen sensor varies the voltage from approximately 1,000 mV when the exhaust is rich, to approximately 10 mV when the exhaust is lean.

The PCM monitors and stores the Heated Oxygen Sensor (HO2S) voltage information. The PCM evaluates the HO2S voltage samples in order to determine the time that the HO2S voltage was out of range. The PCM compares the stored HO2S voltage samples taken within each sample period, and determines if the majority of the samples are out of the operating range.

The PCM monitors the HO2S voltage and detects if the voltage goes out of the bias range. If the PCM does not detect that the voltage went out of the bias range, a DTC sets.

CONDITIONS FOR RUNNING THE DTC
^ DTCs P0101, P0102, P0103, P0106, P0107, P0108, P0112, P0113, P0117, P0118, P0121, P0122, P0123, P0200, P0300, P0410, P0440, P0442, P0446, P0452, P0453, P1258, P1415, P1416, or P1441 are not set.
^ The ignition 1 signal is between 9-18 volts.
^ The secondary Air Injection (AIR) and the catalyst diagnostics are not active.
^ The loop status is Closed.
^ The engine run time is more than 409 seconds.

CONDITIONS FOR SETTING THE DTC
^ The HO2S signal voltage remains between 350-550 mV.
^ The conditions are present for 57 seconds.

ACTION TAKEN WHEN THE DTC SETS
^ The control module illuminates the Malfunction Indicator Lamp (MIL) on the second consecutive ignition cycle that the diagnostic runs and fails.
^ The control module records the operating conditions at the time the diagnostic fails. The first time the diagnostic fails, the control module stores this information in the Failure Records. If the diagnostic reports a failure on the second consecutive ignition cycle, the control module records the operating conditions at the time of the failure. The control module writes the operating conditions to the Freeze Frame and updates the Failure Records.

CONDITIONS FOR CLEARING THE MIL/DTC
^ The control module turns OFF the Malfunction Indicator Lamp (MIL) after 3 consecutive ignition cycles that the diagnostic runs and does not fail.
^ A current DTC "Last Test Failed" clears when the diagnostic runs and passes.
^ A history DTC clears after 40 consecutive warm-up cycles, if no failures are reported by this or any other emission related diagnostic.
^ Use a scan tool in order to clear the MIL and the DTC.

TEST DESCRIPTION

Steps 1-7:

Steps 8-13:

The numbers below refer to the step numbers on the diagnostic table.
2. Before you perform this test, the engine must be at the normal operating temperature.
3. The Freeze Frame/Failure Records data may help to locate an intermittent condition. If you cannot duplicate the DTC, the information in the Freeze Frame/Failure Records data can help to determine how many miles have occurred since the DTC set. The Fail Counter and the Pass Counter can also help to determine the number of ignition cycles during which the diagnostic reported a pass and/or a fail. In order to isolate when the DTC failed, operate the vehicle within the same Freeze Frame conditions that the PCM recorded. These conditions include the RPM, the vehicle load, the vehicle speed, and the temperature.
4. If the scan tool indicates the HO2S voltage goes below 200 mV, the HO2S circuits and PCM are OK.
5. This step verifies whether the signal circuit from the PCM is OK.
6. This step verifies whether the low signal circuit from the PCM is OK. A voltage indicates the PCM and wiring are OK.
7. Disconnecting the PCM allows using a DMM in order to test the circuit continuity. This procedure helps to locate a circuit that is open or shorted.