Rear Folding Seat Back Latch Striker Replacement

Rear Folding Seat Back Latch Striker Replacement

Removal Procedure




1. Remove the striker bolt (3) from the wheel house panel.
2. Remove the washer (1) from the striker bolt (3).
3. Remove the sleeve (2) from the striker bolt (3).

Installation Procedure




1. Install the sleeve (2) over the striker bolt (3).
2. Install the washer (1) over the striker bolt (3).

Notice: Refer to Fastener Notice in Service Precautions.

3. Install the striker bolt (3) to the wheel house panel.

Tighten the bolt to 35 N.m (26 lb ft).