78. Cylinder Head Installation - Right
Cylinder Head Installation - Right- Tools Required
- J 36660-A Torque Angle Meter
Important: Do not reuse the M11 cylinder head bolts. Install NEW M11 cylinder head bolts during assembly.
Do not use any type sealant on the cylinder head gasket (unless specified).
The cylinder head gaskets must be installed in the proper direction and position.
Caution: Refer to Safety Glasses Caution in Service Precautions.
Notice: Clean all dirt, debris, and coolant from the engine block cylinder head bolt holes. Failure to remove all foreign material may result in damaged threads, improperly tightened fasteners or damage to components.
1. Clean the engine block cylinder head bolt holes (if required).
Thread repair tool J 42385-107 may be used to clean the threads of old threadlocking material.
2. Spray cleaner GM P/N 12346139, P/N 12377981, or equivalent into the hole.
3. Clean the cylinder head bolt holes with compressed air.
4. Check the cylinder head locating pins for proper installation.
5. Install the NEW right cylinder head gasket onto the locating pins.
Important: When properly installed, the tab on the right cylinder head gasket will be located right of center, or closer to the front of the engine, and the words "This Side Up", and the engine displacement will be visible.
6. Inspect the gasket for proper installation.
7. Install the cylinder head onto the locating pins and the gasket.
8. Install the NEW M11 cylinder head bolts.
9. Apply a 5 mm (0.2 inch) band of threadlock GM P/N 12345382 or equivalent to the threads of the M8 cylinder head bolts.
10. Install the M8 cylinder head bolts.
Notice: Refer to Fastener Notice in Service Precautions.
11. Tighten the cylinder head bolts.
11.1. Tighten the M11 cylinder head bolts (1-10) a first pass in sequence to 30 Nm (22 ft. lbs.).
11.2. Tighten the M11 cylinder head bolts (1-10) a second pass in sequence to 90 degrees using the J 36660-A.
11.3. Tighten the M11 cylinder head bolts (1,2,3,4,5,6,7,8) to 90 degrees and the M11 cylinder head bolts (9 and 10) to 50 degrees a final pass in sequence to using the J 36660-A.
11.4. Tighten the M8 cylinder head bolts (11, 12,13,14,15) to 30 Nm (22 ft. lbs.). Begin with the center bolt (111) and alternating side-to-side, work outward tightening all of the bolts.