Firebird

PARK/[1][2]TURN SIGNAL LAMP REPLACEMENT

REMOVAL PROCEDURE




1. Raise and suitably support the vehicle.
2. Open the access door in the front bumper air deflector.
3. Disconnect the electrical connector from the park and [1][2]turn signal lamp.
4. Remove the park and [1][2]turn signal lamp nuts.
5. Remove the park and [1][2]turn signal lamp (2) from the fascia.

INSTALLATION PROCEDURE




1. Install the park and [1][2]turn signal lamp (2) to the fascia.

NOTE: Refer to Fastener Notice in Service Precautions.

2. Install the park and [1][2]turn signal lamp boils.

Tighten
Tighten the park and [1][2]turn signal lamp nuts to 4 N.m (35 lb in).

3. Connect the electrical connector to the park and [1][2]turn signal lamp.
4. Close the access door in the front bumper air deflector.
5. Lower the vehicle.