Accessory Drive Belt Replacement
Drive Belt Replacement - AccessoryRemoval Procedure
1. Disconnect the following electrical connectors:
- Intake Air Temperature (IAT) sensor
- Mass Airflow (MAF) sensor
2. Remove the air intake duct from the following:
- Throttle body
- Air cleaner box
3. Install a breaker bar with hex-head socket to the drive belt tensioner bolt.
4. Rotate the drive belt tensioner clockwise in order to relieve tension on the belt.
5. Remove the belt from the pulleys and the drive belt tensioner.
6. Slowly release the tension on the drive belt tensioner.
7. Remove the breaker bar and socket from the drive belt tensioner bolt.
8. Clean and inspect the belt surfaces of all the pulleys.
Installation Procedure
1. Route the drive belt around all pulleys, except the water pump and belt tensioner.
2. Install the breaker bar with hex-head socket to the belt tensioner bolt.
3. Rotate the belt tensioner clockwise in order to relieve the tension on the tensioner.
4. Install the drive belt under the water pump pulley.
5. Install the drive belt onto the belt tensioner.
6. Slowly release the tension, on the belt tensioner.
7. Remove the breaker bar and socket from the belt tensioner bolt.
8. Inspect the drive belt for proper alignment.
9. Install the air intake duct to the following:
- Throttle body
- Air cleaner box
10. Connect the following electrical connectors:
- MAF sensor
- IAT sensor