Heated Oxygen Sensor (HO2S) Replacement Bank 1 Sensor 2

REMOVAL PROCEDURE

NOTE:
^ Refer to Heater Oxygen and Oxygen Sensor Notice in Service Precautions.
^ Refer to Excessive Force and Oxygen Sensor Notice in Service Precautions.




1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle.
2. Disconnect the HO2S electrical connector.




3. Carefully back out the heated oxygen sensor.

INSTALLATION PROCEDURE

IMPORTANT: A special anti-seize compound is used on the heated oxygen sensor threads. The compound consists of graphite suspended in fluid and glass beads. The graphite will burn away, but the glass beads will remain, making the sensor easier to remove. New or service sensors will already have the compound applied to the threads. If a sensor is removed from an engine and if for any reason that sensor is to be reinstalled, the threads must have anti-seize compound applied before reinstallation.




1. Coat the threads of the heated oxygen sensor with anti-seize compound P/N 5613695, or the equivalent if necessary.

NOTE: Refer to Fastener Notice in Service Precautions.

2. Install the heated oxygen sensor.

Tighten
Tighten the HO2S to 41 N.m (30 lb ft).




3. Connect the HO2S electrical connector.
4. Lower the vehicle.