Ground Strap: Service and Repair
GROUND STRAP REPLACEMENTREMOVAL PROCEDURE
1. Remove the tie strap at the power steering line.
2. Remove the engine wiring harness ground bolt (1) at the block.
3. Disconnect and reposition the oxygen sensor electrical connector.
4. Remove the wiring harness ground bolt (at frame).
5. Remove the tape attaching the ground strap to the wiring harness.
6. Remove the ground strap from the vehicle.
INSTALLATION PROCEDURE
1. Install the ground strap to the vehicle.
2. Wrap new tape around the ground strap and the wiring harness.
NOTE: Refer to Fastener Notice in Service Precautions.
3. Install the wiring harness ground bolt.
Tighten
Tighten the wiring harness ground bolt to 12 N.m (106 lb in).
4. Connect and position the oxygen sensor electrical connector.
5. Install the engine wiring harness ground bolt (1) at the block.
Tighten
Tighten the engine wiring harness ground bolt to 25 N.m (18 lb ft).