Ignition Lock Cylinder

Removal Procedure





1. Remove the steering wheel from the steering column. Refer to Steering Wheel Replacement.
2. Insert the ignition key into the lock cylinder.
Leave the key in the LOCK position.





3. Remove the lock retaining screw (2).
4. Remove the lock cylinder (1) and harness (4), perform the following:
4.1. Disconnect the terminal connector from the bulkhead connector.
4.2. Remove the wiring protector.
4.3. Disconnect the retaining clip (3) from the lock housing cover sleeve.
4.4. Pull the wire harness (4) through the steering column.
4.5. Remove the lock cylinder (1) from the steering column.

Installation Procedure





1. Install the lock cylinder (1) and harness (4), perform the following:
1.1. Install the lock cylinder (1) to the vehicle.
1.2. Pull the wire harness (4) through the steering column.
1.3. Connect the retaining clip (3) to the lock housing cover sleeve.
1.4. Install the wiring protector.
1.5. Connect the terminal connector to the bulkhead connector.

Notice: Refer to Fastener Notice in Service Precautions.

2. Install the lock retaining screw (2).
- Tighten the lock retaining screw to 2.5 Nm (22 inch lbs.).





3. Remove the ignition key from the lock cylinder.
4. Install the steering wheel to the steering column. Refer to Steering Wheel Replacement.