To Express Open to Vent

To open the power sunroof to the vent position from the closed position turn the ignition to ON with engine OFF. Momentarily press the sunroof switch rearward (non-grip side). Activating this switch applies the sunroof switch low reference to the sunroof open signal circuit (5 volt reference) input, pulling the reference voltage to 0 volts. As long as the sunroof module only see a single input request from the sunroof switch (open signal circuit), the module will automatically (express open) open the sunroof glass to the full vent position, raising the rear of the glass upward. The sunroof glass will stop (soft stop) at the full vent position based on the inputs from the limit switches. The sunshade will have to be manually slid closed. To stop the sunroof glass in a desired vent position other than full open either:
^ Momentarily press the sunroof switch again to stop express to vent.
^ Instead of momentarily pressing the sunroof switch to express to vent, maintain pressing the sunroof switch rearward until the glass reaches a desired vent position then release the switch.