Seat Adjuster Horizontal Actuator Replacement

Seat Adjuster Horizontal Actuator Replacement

Removal Procedure

Important: Place the front seat in the highest vertical setting prior to removal. This is necessary to gain access to the horizontal actuator bolts.




1. Remove the front seat from the vehicle.
2. If the actuator is next to the horizontal motor you will have to remove motor support bracket. Refer to Front Seat Adjuster Motor Replacement.
3. Squeeze the oblong connector at the horizontal actuator (10).
4. Remove the bolts (6) from the horizontal actuator (10).
5. Remove the actuator (10) from the upper channel (3).

Installation Procedure




1. Install the actuator (10) to the upper channel (3).

Notice: Refer to Fastener Notice in Service Precautions.

2. Install the bolts (6) to the horizontal actuator (10).

Tighten the bolts to 11 N.m (97 lb in).

3. Install the horizontal drive cable into the actuator (10).
4. Push the oblong connector into the horizontal actuator (10) until a loud audible click is heard.
5. Install the motor support bracket, if previously removed.
6. Install the front seat to the vehicle.