93. Crankshaft Balancer Installation

Crankshaft Balancer Installation
- Tools Required
- J29113 Crankshaft Balancer Installer
- J36660-A Torque Angle Meter

1. Apply sealer GM P/N 12345739 or the equivalent to the keyway of the crankshaft balancer.
2. Place the crankshaft balancer into position over the key in the crankshaft.





3. Install the J29113 onto the crankshaft.
4. Pull the crankshaft balancer into position.
5. Remove the J29113 from the crankshaft balancer.

Notice: Refer to Fastener Notice in Service Precautions.





6. Install the crankshaft balancer washer and bolt.
- Tighten the crankshaft balancer bolt a first pass to 70 Nm (52 ft. lbs.).
- Tighten the crankshaft balancer bolt a second pass to 85 degrees using the J36660-A.