Aiming Headlamps (Visual Aim)

1. Prepare the vehicle. Refer to Aim Preparation.
2. Park the vehicle square with the screen. Locate the headlamps directly over the reference line.
3. Ensure that all the components are in place if other work has been done on the vehicle.
4. Use the following procedure in order to line up the centerline of the vehicle with the centerline (2, 3) of the aiming screen:
4.1. Mark the vertical center of the vehicle and the front windows using tape.
4.2. Use these lines as sights in order to line up the centerline of the vehicle and the screen.
5. Adjust the vertical tapes on the screen to match the vertical centerline (1) of each lamp. Measure the distance from the centerline of the vehicle to the centerline of a low beam lamp.
6. Adjust the horizontal tapes (2) on the screen to match the horizontal centerline of the low beam headlamp. Measure the height from the floor to the center of a low beam.




7. Turn on the low beam lamps. Adjust the headlamps in the following manner:
7.1. The left edge of the high intensity zone on the screen for the low beams is on the vertical line (5) for each side.
7.2.. The top edge of the high intensity zone on the screen for the low beam is on the horizontal line (2) for each side.