Repair Instructions
TRACTION CONTROL SWITCH REPLACEMENTREMOVAL PROCEDURE
1. Remove the Instrument panel accessory trim plate.
2. Remove the screws from the switch retainer bracket.
3. Remove the retainer bracket from the accessory trim plate.
4. Remove the traction control switch from the switch retainer bracket use a small flat-bladed tool in order to depress and release the flasher retainers, while pressing the flasher and switch out with your thumb.
INSTALLATION PROCEDURE
1. Position the flasher and switch to the switch retainer bracket.
2. Install the flasher and switch to the switch retainer bracket pressing into place until fully seated.
3. Position the retainer bracket to the accessory trim plate.
NOTE: Refer to Fastener Notice in Service Precautions.
4. Install the screws to the switch retainer bracket.
Tighten
Tighten the switch retainer bracket screws to 3 N.m (27 lb in).
5. Install the instrument panel accessory trim plate.