P0446

DESCRIPTION
A RESTRICTED or BLOCKED EVAP VENT PATH is detected by the Powertrain Control Module (PCM) monitoring the fuel tank pressure during normal operation. The PCM commands the EVAP vent valve OFF (open), and the EVAP canister purge Valve ON (open). The Fuel Tank Pressure (FTP) should remain low as vacuum is drawn on the EVAP system. If the Vent path is blocked or restricted, the vacuum level will increase and DTC P0446 will set.

CONDITIONS FOR RUNNING THE DTC
^ DTCs P0107, P0108, P0112, P0113, P0117, P0118, P0121, P0122, P0123, P0125, P0440, P0442, P0443, P0449, P0452, P0453, P1106, P1107, P1111, P1112, P1114, P1115, P1121, or P1122 are not set.
^ The ignition voltage is between 10-18 volts.
^ The Barometric Pressure (BARO) is more than 75 kPa.
^ The fuel level is between 15-85 percent.
^ The Engine Coolant Temperature (ECT) is between 4-30°C (39-86°F).
^ The Intake Air Temperature (IAT) is between 4-30°C (39-86°F).
^ The start up ECT and IAT are within 9°C (16°F) of each other.
^ The Vehicle Speed Sensor (VSS) is less than 121 km/h (75 mph).

CONDITIONS FOR SETTING THE DTC
^ The fuel tank pressure is less than -10 inch H2O.
^ The condition is present for at least 30 seconds.

ACTION TAKEN WHEN THE DTC SETS
^ The control module illuminates the Malfunction Indicator Lamp (MIL) on the second consecutive ignition cycle that the diagnostic runs and fails.
^ The control module records the operating conditions at the time the diagnostic fails. The first time the diagnostic fails, the control module stores this information in the Failure Records. If the diagnostic reports a failure on the second consecutive ignition cycle, the control module records the operating conditions at the time of the failure. The control module writes the operating conditions to the Freeze Frame and updates the Failure Records.

CONDITIONS FOR CLEARING THE MIL/DTC
^ The control module turns OFF the Malfunction Indicator Lamp (MIL) after 3 consecutive ignition cycles that the diagnostic runs and does not fail.
^ A current DTC, Last Test Failed, clears when the diagnostic runs and passes.
^ A history DTC clears after 40 consecutive warm-up cycles, if no failures are reported by this or any other emission related diagnostic.
^ Use a scan tool in order to clear the MIL and the DTC.

DIAGNOSTIC AIDS
An intermittent condition could be caused by a damaged EVAP Vent housing, a temporary blockage at the EVAP vent Valve inlet or a pinched vent hose. A blockage in the vent system will also cause a poor fuel fill problem. To repair a blockage in the EVAP system. Refer to Evaporative Emission (EVAP) System Cleaning. Evaporative Emissions System

TEST DESCRIPTION

Steps 1-4:

Steps 5-13:

The number below refers to the step number on the diagnostic table.
4. This test determines if the failure is present or intermittent.