86. Air Injection Check Valve Installation
Air Injection Check Valve InstallationNotice: Refer to Fastener Notice in Service Precautions.
1. Install air injection check valve pipe adapters, rear.
- Tighten the air injection check valve pipe adapters to 30 Nm (22 ft. lbs.).
2. Install air injection check valve pipe adapters, front.
- Tighten the air injection check valve pipe adapters to 30 Nm (22 ft. lbs.).
3. Install air injection check valve rear bracket and nuts.
- Tighten the air injection check valve rear bracket nuts to 25 Nm (18 ft. lbs.).
4. Install air injection check valve front bracket, bolt and nut.
- Tighten the air injection check valve front bracket bolt and nut to 25 Nm (18 ft. lbs.).
5. Install air injection check valve rear.
- Tighten the air injection check valve to 20 Nm (1 5 ft. lbs.).
6. Install air injection check valve nut, rear.
- Tighten the air injection check valve nut rear to 10 Nm (89 inch lbs.).
7. Install air injection check valve front.
- Tighten the air injection check valve front to 20 Nm (15 ft. lbs.).
8. Install air injection check valve nut front.
- Tighten the air injection check valve nut to 10 Nm (89 inch lbs.).
9. Install air injection solenoid switch and bolt.
- Tighten the air injection solenoid switch bolt to 10 Nm (89 inch lbs.).
10. Install air injection check valve pipe, clamps, and bolt.
- Tighten the air injection check valve pipe bolt to 10 Nm (89 inch lbs.).
11. Install air injection vacuum hose.