Fuel Tank Pressure Sensor: Service and Repair
FUEL TANK PRESSURE SENSOR REPLACEMENTREMOVAL PROCEDURE
1. Remove the trunk liner. Refer to Compartment Trim Panel Replacement - Rear in Trunk/Liftgate.
2. Remove the fuel sender access panel.
3. Disconnect the electrical connector from the fuel tank pressure sensor.
4. Remove the fuel tank pressure sensor (7) from the fuel sender assembly.
INSTALLATION PROCEDURE
1. Install a new seal provided with the fuel tank pressure sensor.
2. Install the new fuel tank pressure sensor (7) to the fuel sender.
3. Connect the electrical connector to fuel tank pressure sensor
4. Install the fuel sender access panel.
NOTE: Refer to Fastener Notice in Caution and Notices.
5. Install the nuts retaining the fuel sender access panel.
Tighten
Tighten the fuel sender access panel nuts to 10 N.m (89 lb in)
6. Install the trunk liner. Refer to Compartment Trim Panel Replacement - Rear in Trunk/Liftgate.