Ignition & Key Alarm Switch

Ignition Switch Replacement- On Vehicle
Removal Procedure





1. Disconnect the negative battery cable from the battery.
2. Disable the SIR system. Refer to Disabling the SIR System in Restraint System.
3. Remove the inflatable restraint steering wheel module. Refer to Inflatable Restraint Steering Wheel Module Replacement in Restraint Systems.
4. Remove the steering wheel.
5. Remove the upper and lower steering column trim covers.
6. Remove the wire harness straps (2) from the steering column and the wire harness assembly (1).





7. Slide the connectors (2) of the turn signal and multifunction switch assembly out of the bulkhead connector (1).





8. Remove the theft deterrent module (2) from the lock module assembly.





9. Remove the key alarm connector (1) from the lock module assembly (2).
9.1. Rotate the key alarm connector (1) 90 degrees.
9.2. Pull the key alarm connector (1) out of the lock module assembly (2).





10. Remove the tapping screws (2) from the ignition and key alarm switch assembly (1).
11. Remove the ignition and key alarm switch assembly (1) from the lock module assembly.

Installation Procedure





1. Install the ignition and key alarm switch assembly (1) onto the lock module assembly.

Notice: Refer to Fastener Notice in Service Precautions.

2. Screw the tapping screws (2) into the ignition and key alarm switch assembly (1).
Tighten the tapping screws to 1.5 Nm (13 inch lbs.).





3. Install the key alarm connector (1) into the lock module assembly (2).
3.1. Push the key alarm connector (1) into the lock module assembly (2).
3.2. Rotate the key alarm connector (1) 90 degrees so that the key alarm connector (1) locks into place.





4. Install the theft deterrent module (2) into the lock module assembly.





5. Slide the (2) connectors of the turn signal and multifunction switch assembly into the bulkhead connector (1).





6. Attach the wire harness straps (1) to the wire harness assembly (2) and the steering column.
7. Install the upper and lower steering column trim covers.
8. Install the steering wheel.
9. Install the inflatable restraint steering wheel module. Refer to Inflatable Restraint Steering Wheel Module Replacement in Restraint Systems.
10. Enable the SIR system. Refer to Enabling the SIR System in Restraint Systems.
11. Connect the negative battery cable to the battery.