Ignition Switch

IGNITION SWITCH REPLACEMENT - ON VEHICLE

REMOVAL PROCEDURE
1. Disconnect the negative battery cable from the battery.
2. Disable the SIR system. Service and Repair
3. Remove the inflatable restraint steering wheel module. Inflatable Restraint Steering Wheel Module Replacement
4. Remove the steering wheel. Steering Wheel Replacement
5. Remove the upper and lower steering column trim covers. Steering Column Trim Covers





6. Remove the wire harness straps (2) from the steering column and the wire harness assembly (1).





7. Slide the connectors (2) of the turn signal and multifunction switch assembly out of the bulkhead connector (1).
8. Remove the ignition lock cylinder. Ignition Lock Cylinder





9. If the vehicle is equipped with a theft deterrent module (2), remove the theft deterrent module (2) from the lock module assembly.





10. Remove the key alarm connector (1) from the lock module assembly (2).
a. Rotate the key alarm connector (1) 90 degrees.
b. Pull the key alarm connector (1) out of the lock module assembly (2).





11. Remove the tapping screws (2) from the ignition and key alarm switch assembly (1).
12. Remove the ignition and key alarm switch assembly (1) from the lock module assembly.

INSTALLATION PROCEDURE





1. Install the ignition and key alarm switch assembly (1) onto the lock module assembly.

NOTICE: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

2. Screw the tapping screws (2) into the ignition and key alarm switch assembly (1).

TIGHTEN
Tapping screws to 1.5 Nm (13 lb in)





3. Install the key alarm connector (1) into the lock module assembly (2).
a. Push the key alarm connector (1) into the lock module assembly (2).
b. Rotate the key alarm connector (1) 90 degrees so that the key alarm connector (1) locks into place.





4. If the vehicle is equipped with a theft deterrent module (2), install the theft deterrent module (2) into the lock module assembly.
5. Install the ignition lock cylinder.





6. Slide the (2) connectors of the turn signal and multifunction switch assembly into the bulkhead connector (1).





7. Attach the wire harness straps (1) to the wire harness assembly (2) and the steering column.
8. Install the upper and lower steering column trim covers.
9. Install the steering wheel.
10. Install the inflatable restraint steering wheel module.
11. Enable the SIR system.
12. Connect the negative battery cable to the battery.