SIR Steering Wheel Module Coil - Assemble

Inflatable Restraint Steering Wheel Module Coil - Assemble - Off Vehicle




1. Align the block tooth on the steering shaft assembly (1) to the 12 o'clock position.
2. Place the ignition switch in the LOCK position.

Important: The new inflatable restraint steering wheel module coil will be pre-centered. Do not remove the centering tab from the new inflatable restraint steering wheel module coil until the installation is complete.





3. If installing the existing inflatable restraint steering wheel module coil, it must be centered first.
4. Align the inflatable restraint steering wheel module coil (4) with the horn tower on the turn signal cancel cam assembly (1).
5. Slide the new inflatable restraint steering wheel module coil (4) onto the steering shaft assembly (2).
6. Firmly seat the retaining ring (3) into the groove on the steering shaft assembly (2).
7. Remove and discard the centering tab from the new inflatable restraint steering wheel module coil (4).





8. Reconnect the inflatable restraint steering wheel module coil connector to the turn signal switch assembly connector.
9. Attach new wire harness straps to the wire harness assembly (1) and the steering column.
10. Install the wire harness assembly (1) into the wire harness strap (2).
11. Install the upper and lower trim covers.