Tie Rod: Service and Repair

NOTE: The content of this article / image reflects the changes called out by TSB: 05-02-32-003


Tie Rod End Replacement - Outer

- Tools Required
- J24319-B Universal Steering Linkage Puller

Removal Procedure





1. Raise and support the vehicle.
2. Remove the tire and wheel assembly.
3. Remove the prevailing torque nut (2) from the outer tie rod assembly (1).





4. Loosen the jam nut (2) on the Inner tie rod assembly (1).

Notice: Do not attempt to disconnect a steering linkage joint by driving a wedge between the joint and the attached part. Seal damage may result which will cause premature failure of the joint.





5. Using the J24319-B remove the outer tie rod assembly from the steering knuckle.





6. Remove the outer tie rod assembly (3) from the inner tie rod assembly (1).

Installation Procedure





1. Install the outer tie rod assembly (3) to the inner tie rod assembly (1).
2. Do not tighten the jam nut (2).





3. Install the outer tie rod assembly (2) to the steering knuckle (1).

Notice: Refer to Fastener Notice in Service Precautions.





4. Install the prevailing torque nut (2) to the outer tie rod assembly (1).
Tighten the prevailing torque nut (2) to 30 Nm (22 ft. lbs.).
Tighten the prevailing torque nut (2) an additional 120 degrees of rotation.


NOTE: Visually inspect to ensure that 2 1/2 - 4 1/2 threads are visible past the nylon washer.






5. Tighten the jam nut (2) against the outer tie rod assembly (3).
Tighten the jam nut to 70 Nm (52 ft. lbs.).
6. Install the tire and wheel assembly.
7. Lower the vehicle.
8. Perform a front end alignment.