Access Cover: Service and Repair

Fuel Injector Sight Shield Replacement (L67)

Removal Procedure
1. Clean the area around the tube/oil fill cap before removing the tube/oil fill cap in order to prevent contaminants from falling into the valve rocker arm cover opening.
2. Twist counter-clockwise to unlock the tube/oil fill cap from the valve rocker arm cover.





3. Remove the upper intake manifold cover nut holding the fuel injector sight shield to the fuel injector rail brace stud.
4. Lift the fuel injector sight shield up at the front and slide the tab out of the engine bracket.
5. Replace the tube/oil fill cap in the valve rocker arm cover.

Installation Procedure
1. Remove the tube/oil fill cap from the engine.
2. Insert the tab of the fuel injector sight shield under the engine bracket.
3. Place the hole of the fuel injector sight shield onto the oil fill neck of the valve rocker arm cover.
4. Install the tube/oil fill cap into the valve rocker err cover and twist clockwise in order to lock the detent on the tube into the notch in the cover.

Notice: Refer to Fastener Notice in Service Precautions.





5. Install the upper intake manifold cover nut holding the fuel injector sight shield to the fuel injector rail brace stud.
^ Tighten the upper intake manifold cover nut to 3 Nm (27 inch lbs.).