Engine Oil Pressure Sensor or Switch Replacement

REMOVAL PROCEDURE

CAUTION: Refer to Battery Disconnect Caution in Service Precautions.




1. Disconnect the negative battery cable.
2. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle.
3. Disconnect the electrical connector from the engine oil pressure switch.
4. Remove the engine oil pressure switch.

INSTALLATION PROCEDURE

NOTE: Refer to Fastener Notice in Service Precautions.




1. Install the engine oil pressure switch.

Tighten
Tighten the engine oil pressure switch to 16 N.m (12 lb ft).

2. Connect the electrical connector to the engine oil pressure switch.
3. Lower the vehicle.
4. Connect the negative battery cable.