To Close

To close the power sunroof press and hold the sunroof switch forward, this will apply the sunroof switch low reference to the sunroof close signal circuit (5 volt reference) input, pulling the reference voltage down to 0 volts. The sunroof switch close signal input to the sunroof module needs to have constant 0 volts applied (switch pressed) to allow the sunroof module to continue to control the sunroof motor circuits to drive the sunroof glass past the vent position until it reaches the closed position. The sunroof glass will stop (soft stop) at the closed position based on the inputs from the limit switches. To close the sunshade, this will have to be manually slid closed.