Head Up Display Module Replacement

REMOVAL PROCEDURE




1. Remove the instrument panel (IP) upper trim pad.
2. Remove the IP head-up display (HUD) module bolts.
3. Disconnect the electrical connector from the HUD module.
4. Remove the HUD module from the instrument panel.

INSTALLATION PROCEDURE




1. Connect the electrical connector to the HUD module.
2. Install the HUD module to the instrument panel.

NOTE: Refer to Fastener Notice in Service Precautions.

3. Install the bolts into the HUD module.

Tighten
Tighten the bolts to 2 N.m (18 lb in).

4. Install the IP upper trim pad.