Accelerator Pedal: Service and Repair
ACCELERATOR CONTROLS PEDAL REPLACEMENTREMOVAL PROCEDURE
1. Remove the left instrument panel sound insulator. Refer to Closeout/Insulator Panel Replacement - Left in Instrument Panel, Gauges and Console.
2. Disconnect the accelerator cable (5) from accelerator pedal (1).
3. Remove the bolts (3) and studs (2) holding the accelerator pedal to the bulk head (4).
4. Remove the accelerator pedal.
INSTALLATION PROCEDURE
IMPORTANT: The throttle should operate freely without binding between a full closed and a wide open throttle.
1. Position the accelerator pedal (1) to the bulkhead (4).
NOTE: Refer to Fastener Notice in Service Precautions.
2. Install the accelerator pedal bolt (3) and the stud (2).
Tighten
Tighten the bolts and studs to 3 N.m (27 lb in).
3. Connect the accelerator cable (5) to the accelerator pedal (1).
4. Install the left instrument panel sound insulator. Refer to Closeout/insulator Panel Replacement - Left in Instrument Panel, Gauges and Console.
5. Inspect for complete throttle opening and closing positions by operating the accelerator pedal. Also inspect for poor carpet fit under the accelerator pedal.