Power Seat Motor: Service and Repair

Front Seat Adjuster Motor Replacement

Removal Procedure





1. Remove the front seat. Refer to Seat Replacement (Seat Replacement) .
2. Disconnect the 3 electrical wiring harness connectors from the seat adjuster motors.




3. If equipped, remove the push-in retainer (2) and tab (1) on the power lumbar harness from the motor bracket.
4. Remove the nut from the seat adjuster motor bracket.




5. Disconnect the drive cables from the seat adjuster motors. Refer to Seat Horizontal and Vertical Drive Cable Replacement (Seat Horizontal and Vertical Drive Cable Replacement) .
6. Remove the seat adjuster motor assembly from the front seat adjuster.



Installation Procedure





1. Position the seat adjuster motor assembly to the front seat adjuster.

Notice: Refer to Fastener Notice in Cautions and Notices.

2. Install the nut to the seat adjuster motor bracket.

Tighten the nut to 10 N.m (89 lb in).

3. Install the drive cables to the seat adjuster motors. Refer toSeat Horizontal and Vertical Drive Cable Replacement (Seat Horizontal and Vertical Drive Cable Replacement) .




4. Connect the electrical wiring harness connectors to the seat adjuster motors.




5. If equipped, install the push-in retainer (2) and tab (1) from the power lumbar harness to the motor bracket.
6. Install the front seat. Refer to Seat Replacement (Seat Replacement) .