79. Cylinder Head Installation - Left

Cylinder Head Installation-Left

^ Tools Required
- J36660-A Torque Angle Meter
1. Install the cylinder head gasket. Ensure the arrows point towards the front of the engine. The left cylinder head gasket has the letter L stamped next to the arrow.

Notice: Refer to Special Fastener Notice in Service Precautions.





2. Install the cylinder head.

Notice: Refer to Fastener Notice in Service Precautions.





3. Install new cylinder head bolts.
^ Tighten the cylinder head bolts to 50 Nm (37 ft. lbs.) in sequence. Using J36660-A rotate each cylinder head bolt an additional 120 degrees.